Fieldmann FDB 2005-E Manual de usuario descargar pdf (Pagina 16)

EN 16

FDB 2005-E

ON/OFF switch | Speed control wheel

5.3 ON/OFF SWITCH

To turn the too ON, slide the ON/OFF switch (1) toward the front of the tool (Fig. 5).

To turn the tool OFF, slide the ON/OFF switch toward the rear of the tool.

Fig. 5

5.4 SPEED CONTROL WHEEL

The speed of the tool can be adjusted to run the tool at speeds varying between 10000 – 18000 RPM by rotating

the speed control wheel (1) located towards the rear of the tool housing (Fig. 6)

To increase the speed, rotate the speed control wheel toward the left side of the tool.

To decrease the speed, rotate the speed control wheel toward the right side of the tool.

Fig. 6

POZNÁMKA: Speed #1 is the lowest speed. MAX is the highest speed. The optimal speed setting will vary

depending upon the type of accessory being used, the surface being worked and the complexity of the

project. For general recommendations, se the chart on the following page.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 137 138

Sin comentarios

Fieldmann FDB 2005-E Manual de usuario Pagina 16